The perfect protection for demanding surfaces
A&P Glass Protect is an excellent product for the temporary protection of windows, doors, facade surfaces and other smooth surfaces during construction activities such as renovation, maintenance, painting and varnishing work, demolition work and plastering work. This self-adhesive static film is made from high quality polyethylene and provides up to 1 month of protection from harmful UV rays by filtering 100% of UV rays. The film is easy to apply thanks to the water-based adhesive and is transparent/translucent. After application, the film can be easily smoothed and removed without leaving any residue. A&P Glass Protect is resistant to water, dust and chemical influences.
Product features
- UV protection up to 2 months
- 100% UV resistant
- Easy to apply
- Transparent/translucent
- Resistant to water, dust, chemical influences and mechanical damage
- No hard glue or adhesive residue remains
- Applicable to various construction activities and smooth surfaces
Use
Before using A&P Glass Protect, ensure the surface is thoroughly cleaned and free of grease, dust, moisture and other contaminants. Remove the protective film and attach the adhesive coated side to the surface to be protected. Then smooth the film carefully to avoid air bubbles. After use, the glass cover can be removed effortlessly and without leaving any adhesive residue.
Useful information
Lay the protective fleece without creases, adhesive side down. Identify and remove any trip hazards. Allow approximately 10 cm overlap between adjacent lengths. Secure the edges with tape if necessary. Our fleece is not suitable for newly laid floors, porous stone, natural stone, marble or clay tiles. For these, we recommend a vapour-permeable version (AP-ATMUNGSAKTIV-dampfoffen). Underfloor heating must be switched off. The surface must be permanently dry, clean, dust-free, resistant to tensile and compressive forces, and free from release agents. Check waxed or varnished wooden and parquet floors, and old or heavily used surfaces, particularly carefully.
Because materials, surfaces and external influences vary, installers must always perform their own on-site suitability tests: removal may leave residue or lift the surface coating. Do not continue using the fleece if its fitness for installation is impaired by holes, tears, insufficient adhesion or film separation. On reuse, dirt may transfer from the fleece to the film during rolling, so check for residue and reduced adhesion before laying again. If the fleece is no longer fit for use, it has reached its wear limit and may need replacement. Weight may vary by 5–10%. Do not pull the film off at a 90° angle to the surface.
Our recommendation
Our technical application recommendations are intended to assist the buyer or installer. They do not remove the obligation to check, under your own responsibility, whether our products are suitable for the intended use. Claims for damages and warranty claims cannot be accepted for self-adhesive products. The ambient temperature when removing the film should be between +15°C and +50°C. Never remove the film in freezing conditions. Rolls can be stored for approximately 6 months under normal indoor conditions (+10 to +30°C) and must be protected from direct sunlight, heat, dust and moisture. After use, the film can be disposed of with normal household/residual waste.