The perfect protection for demanding surfaces
Our fleece made of synthetic fibers offers optimal protection for freshly laid floors, natural stone, marble, parquet, laminate, stairs, textile floors, ceramics and tiles. The vapor-permeable PE film on the top prevents liquid accumulation and allows moisture to evaporate, while the non-slip bottom guarantees a secure grip. Waterproof, durable and supple - for a secure hold and easy application. With high abrasion resistance, wipeable surface and clean cut edges, the fleece is ideal for precise, wrinkle-free laying. Perfect for professionals and DIY enthusiasts who want to reliably protect floors. Efficient, safe and high quality - the best choice for floor coverings!
Product features
- Waterproof thanks to PE film
- Non-slip bottom and super adhesive
- Cuddly and firm hold
- Can be swept and wiped clean
- High abrasion resistance
- Clean-cut edges
- Easy, crease-free installation
Use
Lay out the strips with the foil side down, overlapping by approx. 10 cm.
Useful information
Suitable for freshly laid floors, porous stone floors, natural stone floors, marble floors, clay slabs, etc. The underfloor heating must be switched off. The surface must be permanently dry, clean, dust-free, tensile/compressive-resistant and free of release agents. Waxed, varnished wooden and parquet floors as well as old or heavily used surfaces should be particularly checked. Due to different materials, substrates and external influences, the processor must always carry out their own suitability tests on site, as there may be a risk that the surface coating may not be removed or detached without leaving any residue.
If the readiness for installation is impaired, such as holes, tears, lack of adhesion or detachment of the film from the fleece, the covering fleece may no longer be used. If the covering fleece is used several times, possible contamination of the fleece can be transferred, so when using it again, pay attention to residues and reduced adhesive strength. If the fleece is no longer ready to be discarded, the wear limit of the covering fleece has been reached and may need to be replaced.
Our recommendation
Our technical application recommendations are intended to assist the buyer or installer. They do not remove the obligation to check, under your own responsibility, whether our products are suitable for the intended use. Claims for damages and warranty claims cannot be accepted for self-adhesive products. The ambient temperature when removing the film should be between +15°C and +50°C. Never remove the film in freezing conditions. Rolls can be stored for approximately 6 months under normal indoor conditions (+10 to +30°C) and must be protected from direct sunlight, heat, dust and moisture. After use, the film can be disposed of with normal household/residual waste.