The perfect protection for demanding surfaces
Our self-adhesive table protector Pro offers maximum protection and comfort. The absorbent fleece top reliably absorbs liquids, the self-adhesive bottom ensures a firm hold on any surface. Cuddly, wipeable and with high abrasion resistance - ideal for precise masking work. Clean cut edges and easy, wrinkle-free laying save time and nerves. Whether professional or do-it-yourselfer, this protective fleece combines functionality with efficiency and is the perfect choice for demanding projects. Protect your surfaces - safely, reliably and effortlessly!
Product features
- Absorbent fleece surface
- Self-adhesive backing with excellent grip
- Conformable with a firm grip
- Can be swept and wiped clean
- High abrasion resistance
- Clean-cut edges
- Easy, crease-free installation
Use
Lay the foil side down.
Useful information
Lay the protective fleece without creases, adhesive side down. Identify and remove any trip hazards. Allow approximately 10 cm overlap between adjacent lengths. Secure the edges with tape if necessary. Our fleece is not suitable for newly laid floors, porous stone, natural stone, marble or clay tiles. For these, we recommend a vapour-permeable version (AP-ATMUNGSAKTIV-dampfoffen). Underfloor heating must be switched off. The surface must be permanently dry, clean, dust-free, resistant to tensile and compressive forces, and free from release agents. Check waxed or varnished wooden and parquet floors, and old or heavily used surfaces, particularly carefully.
Because materials, surfaces and external influences vary, installers must always perform their own on-site suitability tests: removal may leave residue or lift the surface coating. Do not continue using the fleece if its fitness for installation is impaired by holes, tears, insufficient adhesion or film separation. On reuse, dirt may transfer from the fleece to the film during rolling, so check for residue and reduced adhesion before laying again. If the fleece is no longer fit for use, it has reached its wear limit and may need replacement. Weight may vary by 5–10%. Do not pull the film off at a 90° angle to the surface.
Our recommendation
Our technical application recommendations are intended to assist the buyer or installer. They do not remove the obligation to check, under your own responsibility, whether our products are suitable for the intended use. Claims for damages and warranty claims cannot be accepted for self-adhesive products. The ambient temperature when removing the film should be between +15°C and +50°C. Never remove the film in freezing conditions. Rolls can be stored for approximately 6 months under normal indoor conditions (+10 to +30°C) and must be protected from direct sunlight, heat, dust and moisture. After use, the film can be disposed of with normal household/residual waste.